Copyright Dcollinsworth All Rights Reserved
WWW.DonnasCrochetDesigns.com
WWW.DonnasCrochetDesigns.com
You can sell any item you make from any of my patterns on this web site. You can not Sell the patterns. I hold all rights to all my patterns.
letter in the white ribbon gluing ends to hold. Decorate face of letter with flowers, also gluing them to hold. If you like, cut a 18” length of ribbon and use it to hand the letter from.
PLACE CARD OR TABLE NUMBER HOLDER:
You will need a 3” terra cotta pot, 2” styrofoam ball, small amount of ribbon, 6” piece of 1\8” dowel, styrofoam to fit inside the little pot, 1\8” wide spool ‘o ribbon (10 yarns) in green and craft glue.
Using a pin and glue, attach one end of the ribbon to the styrofoam ball. Carefully wrap the ribbon around the ball gluing and pinning as you go. Let dry and remove the pins. Glue the flowers to the ribbon covered ball. Cut a 10” piece of 1\8” wide pin ribbon and glue at the base of the flower covered ball. Insert dowel. Glue piece of strofoam into pot, insert other end of dowel. Either place table number or place card in the top of the flower ball or on the pot.
Using a pin and glue, attach one end of the ribbon to the styrofoam ball. Carefully wrap the ribbon around the ball gluing and pinning as you go. Let dry and remove the pins. Glue the flowers to the ribbon covered ball. Cut a 10” piece of 1\8” wide pin ribbon and glue at the base of the flower covered ball. Insert dowel. Glue piece of strofoam into pot, insert other end of dowel. Either place table number or place card in the top of the flower ball or on the pot.